Bead Dispenser Kit
2
3A5205A
Bead Dispenser Kit
Setup
NOTE:
Glass bead system and paint guns can be
mounted on either side of sprayer.
1. Perform
Pressure Relief Procedure
(see sprayer
manual).
2. Attach bead mounting bracket (20) to frame.
3. Bolt bead hopper frame legs (1, 3) to bracket (20)
with four flange head cap screws (9) and lock nuts
(10).
4. Place bead hopper ring (14) into holes in bead hop-
per legs.
5. Bolt bead hopper and bead hopper ring together
with washers (15) and lock nuts (4) from kit bag.
6. Install bead hopper (7) on gun side on top of beads
hopper frame.
7. Remove collar from mounting block of dispenser
(8). Locate dispenser on gun support and reconnect
collar to attach dispenser to support.
8. Move bead dispenser to desired location on rod.
Loosen screw (4) and position link (3) to connect to
gun trigger actuator (C). Tighten screw (4) and
attach dispenser connecting rod (B) to gun trigger
with bridge pin (2).
9. Position spray gun and bead dispenser assembly
(D) to position to be used in bead application and
tighten.
10. Attach bead hose(s) (12).
a. 6-inch: Attach bead hose (12) to bead hopper
outlet with hose clamp (11). Plug other bead
hopper outlet with cap (13) and clamp (11).
b. 12-inch: Attach two bead hoses (12) to bead
hopper outlets with hose clamps (11).
11. Route bead hose down to bead dispenser inlet.
NOTE:
To avoid bead stoppage in hose during use,
make sure bead hose is in an arc curved downward with
no kinks or high spots.
12. Mark on bead hose where it will connect to bead
dispenser inlet.
13. Cut bead hose on mark and attach to bead
dispenser inlet using clamp (11). Hoses must be cut
as short as possible to allow good bead flow.
