Bead Dispenser Kit
4
3A5205A
Dispenser Adjustments
Adjust dispenser plates up or down for desired bead
flow. Typical flow rates range between 6 - 8 lb of glass
beads per gallon of paint.
Bead dispensers (A) are located behind paint guns. If
not adjusted properly, dispensers may miss a short area
at end of each paint stripe. Adjust gun cables so guns
trigger at midpoint of handle bar trigger. Adjust bead dis-
pensers (A) so beads flow immediately when trigger is
pulled. This ensures independent control to keep beads
flowing after paint is turned off.
Operation
Operate the striper as in normal striper operation. Refer
to LineLazer Repair manual for paint spray tip recom-
mendations.
Only use dry, clean beads. Any moisture or contamina-
tion with beads will cause poor bead flow. A window
type screen can be used to remove unwanted debris
before filling glass bead hopper.
NOTE:
To avoid bead stoppage, do not use wet beads
or beads that have absorbed moisture. If bead stoppage
is occurring, replace with dry beads.
NOTICE
Do not get beads in paint. Beads contaminating the
paint supply can damage the pump. Make sure paint
supply is covered during bead filling and handling.
4-12 inch stripe
4 inch stripe
6 inch stripe
(10 cm)
(10-30 cm)
(15 cm)
4"
4"
4"
Requires two guns and one 12 in. bead dispenser
(see following page for 8 - 10 in. stripe gun orientation).
ti6590a
