![background image](http://html.mh-extra.com/html/graco/line-lazer-gm-5000-series/line-lazer-gm-5000-series_instructions-and-parts-list_2250927038.webp)
Reassembly
1. Install the
clutch housing (61)
, capscrews (157)
and lockwashers (156) on the engine. See Fig. 44.
2. Install the engine shaft
key (66).
See Fig. 44.
3. Install the
clamp (68)
onto the engine shaft (A).
Maintain the 1.99 in. +/– 0.01 (50.55 mm) dimension
shown in Fig. 45.
To check the dimension, place a rigid, straight steel
bar (B) across the face of the clutch housing (61).
Use an accurate measuring device to measure the
distance between the inside of the bar and the face
of the clamp. Adjust the clamp as necessary. Torque
the two screws (60) to 125 in–lb (14 N.m).
4. Connect the wires of the harness (58) to the screws
(57) in both places on the field. Pull the plastic caps
(C) up and snap them over the screws. Guide the
wires of the harness (58) through the slot in the clutch
housing. Slide the
field (70)
into the clutch. Align the
setscrew chamfers in the field and the clutch housing
(61). T ighten the setscrews (62) oppositely and
evenly, to 25 in–lb (2.8 N.m). See Fig. 44.
Fig. 44
Connect wiring harness (58) here before
sliding field (70) into housing (61)
Torque oppositely and evenly
to 25 in–lb (2.8 N.m)
57
58
70
68
156
157
61
66
60
A
Torque to 125 in–lb (14 N.m)
62
C
D
0049
1
3
2
1
2
3
Fig. 45
1.99” (50.55 mm)
60
SIDE CUTAWAY VIEW OF CLUTCH HOUSING
A
B
61
Face of housing
0050
1
3
2
1
2
3
Torque to 125 in–lb (14 N.m)