Graco HVLP-Turbine Gun, Instructions-Parts List Manual

Page: 6 / 26

Setup
6 309205R
NOTES:
• Control over-spray mist by using only as much air as
necessary to spray fluid. Lighter fluids require less
air.
• If atomization is still unacceptable, fluids may be
thinned further or a different fluid set may be
required. Refer to page 8 to determine fluid set or
page 9 to prepare fluid.
Spray Pattern Direction and
Shape
The spray pattern and direction are determined by the
pattern selection knob (A) fluid adjustment knob (21)
and air cap (15) positions. Fig. 6.
F
IG
. 6
Selecting the Pattern Shape
The Pattern Selection Knob (A) determines the shape of
the spray pattern. To create a round spray pattern set
the pattern selection knob (A) to RND. To create a fan
pattern, set the pattern selection knob (A) to FAN. Fig. 7.
F
IG
. 7
Adjusting the Pattern
Change the pattern by adjusting the fluid knob (21) and
pattern selection knob (A).
Note: Reducing fluid flow rate or turning air knob to
RND will reduce pattern width. Using air cap 244227
will create a highly productive, wider pattern. Fig. 8.
The air control (B) controls the TOTAL air to the pattern
and gun. Fig. 6.
As the fluid flow rate is reduced, the pattern becomes
smaller.
Using too much air will cause overspray.
F
IG
. 8
21
T10746
15
A
B
Round pattern
Set knob to RND
Vertical pattern
Set knob to FAN
A
Horizontal pattern
Set knob to FAN
Pattern selection
knob, adjusts fan
pattern.
TI0825
_
+
TI0812
_
+