Service
310622C
19
4.
Pull the two actuator pistons (11). Remove the
u-cups (10) from the pistons. Pull the pilot pins (14).
Remove the o-rings (15) from the pilot pins. See
F
IG
. 7.
5.
Inspect the valve plate (8) in place. If damaged, use
a Torx (T20) screwdriver or 7 mm (9/32”) socket
wrench to remove the three screws (3). Remove the
valve plate (8) and seal (9). See F
IG
. 8.
6.
Inspect the bearings (12, 17) in place. See
Parts
page 31. The bearings are tapered and, if damaged,
must be removed from the outside. This requires
disassembly of the fluid section. See page 25.
7.
Clean all parts and inspect for wear or damage.
Replace as needed. Reassemble, page 20.
F
IG
. 7
ti4617
10
◆
11
15
◆
14
F
IG
. 8
ti4618
3
8
9
◆
