Graco HEH006, Installation, Repair, And Parts, Page: 18 / 26

Repair
18 3A8216B
5. Loosen and remove the hex nut and hose clamp
(F
IG
. 14).
6. Disconnect the hose (B) from the swivel (C) (F
IG
.
16).
7. Install the hose stop (D) to the end of the
replacement hose. If the hose has a warning tag (F),
the hose stop (D) should be installed on the same
end as the warning tag (F) (F
IG
. 15).
.
NOTE: If the hose is equipped with a spring guard, this
end must be on the same end as the hose stop.
8. Insert screws through the hose stop and hand
tighten the nuts to hold the hose stop in place (F
IG
.
13).
9. Run the end of the hose (B) through the hose guide
(G), and then through the hole (E) in the reel (F
IG
.
16).
10. Attach the hose end (B) to the hose reel swivel (C)
(F
IG
. 16).
11. Attach the hose to the hose clamp and tighten the
hex nut until secured.
12. Remove the C-clamp (A) (F
IG
. 12).
.
13. Pull the hose (B) hard enough to release the latch
and slowly allow the hose to retract.
14. If used, re-assemble the hose reel enclosure.
15. Adjust the spring tension, see Adjust Spring
Tension , page 14.
16. Flush the hose reel following the Flush the
Equipment instructions, page 13.
F
IG
. 14
F
IG
. 15
Hose Clamp
Hex Nut
D
F
Replacement
Hose
F
IG
. 16
C
B
D
G
E