Repair
3A5578C
25
1. Raise the Drum Engage Lever to the up position so
the cutter drum is off the ground.
2. Remove the four hex head cap screws from the
Drum Access Panel using the 9/16” socket or
wrench.
3. Remove the Drum Access Panel (this may require
the rubber mallet to break it loose).
4. Slide out drum assembly (use caution as it is
heavy).
5. Once the cutter drum is removed take to a
workbench for assembly.
a. Inspect condition of cutters, spacers, shafts,
bushings and drum.
6. Before replacing the drum onto hex shaft:
a. Check that all bearings are in good working
order.
b. Remove dirt and material build-up from inside
drive carriage and drum.
c. Lube all metal contacts.
7. Align and slide drum back onto the hex shaft.
8. Replace Drum Access Panel (lift up and lock into
place) over hex shaft and secure hardware.
NOTE: An extra drum loaded with cutters for rapid job
site replacement is recommended.
Belt Replacement (Standard
Models)
Normal wear may necessitate belt tensioning or
replacement. Time of replacement will vary according to
usage and belt load factors.
Replacement is easy and requires a few hand tools.
1. 17mm wrenches.
2. 1/2” socket or wrench.
3. 13mm socket or wrench.
4. Rubber mallet.
1. Make sure the Drum Access Panel is installed. This
ensures the drive ends are in the proper position for
servicing.
2. Clean the machine exterior so you can locate all the
appropriate parts.
3. Using a 17mm socket or wrench, remove the two
hex bolts attaching the belt cover to the side of the
machine. Remove the cover and set it aside.
To avoid injury from unexpected start up, disconnect
spark plug wire before you service your unit.
To avoid injury from unexpected start up, disconnect
spark plug wire before you service your unit.
