Setup
10
3A5578C
4. Slide out drum assembly (use caution as it is
heavy).
5. Once the cutter drum is removed take to a
workbench for assembly.
a. Inspect condition of cutters, spacers, shafts,
bushings and drum.
6. Before replacing the drum onto hex shaft:
a. Check that all bearings are in good working
order.
b. Remove dirt and material build-up from inside
drive carriage and drum.
c. Lube all metal contacts.
7. Align and slide drum back onto the hex shaft.
8. Replace Drum Access Panel (lift up and lock into
place) over hex shaft and secure hardware.
NOTE: An extra drum loaded with cutters for rapid job
site replacement is recommended.
Vacuum Attachment
1. If using a vacuum, attach vacuum hose to the
Vacuum Port.
2. Attach vacuum hose to the Inlet Port on the Cyclone
Separator (optional) or vacuum. \
