![background image](http://html1.mh-extra.com/html/graco/entertainer-4118/entertainer-4118_owners-manual_2250151003.webp)
5
291-12-97
6
8
7
Step 9.
Assemble the toys on the tray as shown. The mirror,
squeaker, and music button are already assembled.
Tighten screw until
clicker does not
move freely—DO
NOT overtighten—
then loosen screw
slightly.
Set duck pond in round
space provided. Then place
retainer ring over it, pushing
all four tabs into slots in tray.
Insert teether
stalk into the tray.
Squeaker
Mirror and music button—
DO NOT allow liquids
around music button.
Mount ring toys onto loop,
then insert ends of loop into
holes on tray. Short end of
loop goes directly over leg.
The loop and ring toys will
not be removable.
Place tumbler
into oval space
as shown, then
use two screws
provided to
attach it from
underneath tray.
DO NOT over-
tighten screw.
NOTE: Most toys may
be removed from tray
for cleaning or storage.
Snaps visible
RIGHT
WRONG
Buttons
Line
To Assemble Your
Entertainer
™
Activity Center
Step 1.
Turn the tray over and
locate the hole that the
seat lock screws into. Place
the seat lock on the tray as
shown and screw it to the
tray. DO NOT overtighten
screw—seat lock must be
free to slide.
Step 2.
Four tabs are located
behind the indentations
inside the seat ring.
Remove the seat ring by
pulling the four tabs out
from under the tray, one
at a time, while lifting the
seat ring.
Step 3.
Put the seat ring upside
down inside the cloth seat.
The high side of the seat
ring goes to the back of the
seat, where the warning
label is located.
Attach the seat to the seat
ring by tucking the seat
edge into the channel and
snapping the grommets on
the pegs.
Step 4.
Turn the seat over and
push the seat down into the
seat ring.
Step 5.
Snap the seat ring back
onto the tray. Make sure all
four tabs are snapped onto
the inside lip.
Pattern side UP
Solid color inside
Grommet
Pattern side
Step 6.
Turn tray over. Push one leg into socket in tray exactly as
shown until it snaps into place. Repeat for other two legs.
Step 7.
On top of tray, CHECK that
snaps are visible through
slots. Pull on leg to be sure it
is securely attached.
Step 8.
Slide the leg tubes on the tray onto the leg tubes on the
base as shown.
HINT: If a tray leg tube will not slide onto the base leg tube,
twist the base tube slightly to line up the parts.
Push in the buttons on each of the upper leg tubes and
adjust the activity center to the desired height.
The bottom edge of the upper tubes must be even with one
of the three lines on the lower leg tube.
CHECK that all three leg tubes are set to the same
height.
To Use the Seat Lock
Push gently on latch and
turn the seat until latch
engages in one of the four
stop positions.
To allow seat to swivel
again, pull lock out.
To Adjust the Seat Height
Do not adjust height while child is in
activity center.
Step 1.
Press in the buttons on
each leg to adjust seat
to desired height. The
bottom edge of the upper
tubes must be even with
one of the three lines on
the lower leg tube.
For your child’s safety, all three legs
must be set to the same height. Tray must be level.
Button
faces seat
(Note:
Squeaker
will not work
in storage
position.)