Graco e-Xtreme, Operation, Repair, And Parts

Page: 15 / 34

Spray
Spray Spray Spray
NOTICE NOTICE
NOTICE
Do not allow pump to run dry. It will quickly
accelerate to a high speed causing damage.
1. Perform Prime/Flush, page 13 .
2. Perform Pressure Relief Procedure, page 12 .
3. Install tip and tip guard onto gun. Close the drain
valve.
4. Turn power switch (E) ON.
ON
5. Pull out and turn pressure adjustment knob
(H) until desired pressure is reached. Turn
clockwise to increase pressure, counterclockwise
to decrease pressure. Push knob in to lock.
6. Disengage gun trigger lock.
7. Spray a test pattern. Read fluid manufacturer’s
recommendations. Adjust as necessary.
NOTE: NOTE: NOTE: When determining the desired spray
pressure, always increase the spray pressure
until the spray pattern fully develops. This will
reduce the pressure surge when the pump is
stalled and minimize over-spray.
Dynamic Dynamic Dynamic Pump Pump Pump Outlet Outlet Outlet Pressure Pressure Pressure
Ex35 Ex35
Ex35 Ex45 Ex45 Ex45
Pressure Pressure
Pressure
Adjust- Adjust- Adjust-
ment ment ment Knob Knob Knob
Setting Setting Setting
PSI PSI PSI Bar Bar Bar MPa MPa MPa PSI PSI PSI Bar Bar Bar MPA MPA MPA
1 320 22.0 2.20 400 27.0 2.70
2 640 44.0 4.40 800 54.0 5.40
3 960 66.0 6.60 1200 81.0 8.10
4 1280 88.0 8.80 1600 108 10.8
5 1600 110 11.0 2000 135 13.5
6 1920 132 13.2 2400 162 16.2
7 2240 154 15.4 2800 189 18.9
8 2560 176 17.6 3200 216 21.6
9 2880 198 19.8 3600 243 24.3
10 3200 220 22.0 4000 270 27.0
8. Flush when finished spraying.
Perform
Prime/Flush, page 13 and
Pressure Relief Procedure, page 12 .
3A3164D 15