![background image](http://html1.mh-extra.com/html/graco/e-flo-1500/e-flo-1500_operation_2253494017.webp)
Maintenance
311593R
17
Flushing
•
Flush before changing colors, before storing, and
before repairing equipment.
•
Flush at the lowest pressure possible. Check con-
nectors for leaks and tighten as necessary.
•
Flush with a fluid that is compatible with the fluid
being dispensed and the equipment wetted parts.
1.
Follow Pressure Relief Procedure, page 14.
2.
Supply the appropriate flushing material to the sys-
tem.
3.
Set pump to lowest possible fluid pressure, and start
the pump.
4.
Flush long enough to thoroughly clean the system.
5.
Follow Pressure Relief Procedure, page 14.
Changing the TSL
Check the condition of the TSL and the level in the res-
ervoir every week, minimum. TSL should be changed at
least every month.
Part No. 206995 Throat Seal Liquid (TSL) carries resi-
due from the pump rod into the reservoir. Discoloration
of the TSL fluid is to be expected during normal opera-
tion. After some time the TSL will thicken and darken,
and must be replaced. Thick, dirty TSL will not pump
through the lines and will harden in the pump wet-cup.
How long TSL lasts depends on which chemicals are
used, how much is used, what pressure, and condition
of the pump seal and rod.
A drop in the level of TSL in the reservoir indicates that
the throat packings are starting to wear. Add TSL to the
reservoir and keep the level above the Minimum fill line.
Monitor the usage and condition of the TSL. If pumped
material bypasses the throat packings and enters the
TSL reservoir, replace the packings.
To change the TSL:
1.
Shut off the pump.
2.
Remove and empty the reservoir bottle. Clean any
residue.
3.
Clean screen (Z) of inlet check valve (VI). If check
valves are not sealing and dirty TSL is getting into
the wet-cup, replace the check valves (VI, VO). See
F
IG
. 11.
4.
Fill the reservoir to the Maximum fill line with Throat
Seal Liquid (TSL).
5.
Run pump. Each time pump rod reaches bottom of
stroke, check that some TSL is pumped from reser-
voir through wet-cup and back to reservoir.
To avoid the buildup of static charge, do not rub the
plastic bottle with a dry cloth while it is attached to the
pump. Remove the bottle to clean, if needed.
F
IG
. 11. Cutaway of TSL Reservoir, and Fill Lines
TI15853a
VO
VI
TI15857a
Maximum Fill Line
Minimum Fill Line
Z
Summary of Contents for E-Flo 1500
Page 4: ...Models 4 311593R...
Page 10: ...Overview 10 311593R...