4
332515F
11. Remove one of the screws (k) from the follower
plate (m) (F
IG
. 7).
12. Install screw (k) through the hole (n) in the cable
bracket (p) located at the end of the low level cable
(j) and then through the screw hole (r) in the follower
plate (m) (F
IG
. 7). Tighten screw securely.
NOTE: Cable bracket (p) is slightly bent. Be sure to
install so the bracket will sit flat against the surface
of the follower plate.
13. Install follower plate (m) on top of grease inside res-
ervoir (h) with the cone side facing up. Press fol-
lower plate firmly into grease to remove all air
pockets.
14. Place reservoir cover (b) on top of reservoir (h).
NOTE: When reservoir cover (b) is correctly
installed on reservoir (h), the low level cable (j)
(installed between the low level indicator and fol-
lower plate (m) will be aligned in a straight and verti-
cal line as shown in F
15. Replace and tighten screws (g) securely (F
. 9).
F
IG
. 7
k
j
p
n
r
m
F
IG
. 8
F
IG
. 9
m
h
b
j
g
