![background image](http://html.mh-extra.com/html/graco/25c528/25c528_instructions-parts-manual_2250908018.webp)
Operation
Operation
Operation
Personal injury, such as splashing in the eyes,
may result from pressure in the tank. Always follow
the
Pressure Relief Procedure, page 19
before
opening the tank cover or fill port.
Personal injury or equipment damage may result
from lifting/falling heavy equipment. To avoid
personal injury or equipment damage:
• Do not lift the drum cover and agitator without
proper assistance.
• Do not walk or stand beneath a raised elevator.
Agitator
Agitator
Agitator Operation
Operation
Operation
1.
Start the agitator by opening the air shutoff valve
(SV). Regulate the speed with the air regulator
knob (R).
2.
Operate the agitator continuously when supplying
paints or other fluids to the system.
3.
Stop the agitator by closing the air shutoff valve
or by reducing pressure with the air regulator
knob.
NOTICE
NOTICE
NOTICE
Always maintain moderate agitator speed.
Excessive agitator speed may cause vibration,
foaming of fluid, and increased wear on parts.
Always agitate fluid thoroughly before supplying it
to the dispensing equipment. Continue agitating
fluid while the dispensing equipment is being
supplied.
Fill the fluid supply container to about 3 or 4 inches
(75 to 100 mm) above the agitator blades to avoid
excessive vibration that could cause damage to
agitator.
Back
Back
Back Gear
Gear
Gear Operation
Operation
Operation
1.
Turn the air regulator knob (R) counterclockwise
to start at zero air pressure.
2.
Open the air shutoff valve (SV).
3.
Use the air regulator knob (R) to adjust the
agitator speed. Look through the inspection port
and gradually increase the speed until you can
see movement in the surface of the liquid. Do
not increase the agitator speed so much that a
vortex forms in the surface of the liquid. If the
surface begins to vortex, decrease the agitator
speed to prevent air entrainment.
NOTICE
NOTICE
NOTICE
Always maintain moderate agitator speed, which
is approximately 50 rpm of the agitator blades.
Excessive agitator speed may cause vibration,
foaming of fluid, and increased wear on parts.
Always agitate fluid thoroughly before supplying it
to the dispensing equipment. Continue agitating
fluid while the dispensing equipment is being
supplied.
18
3A4792G