Retrofit
Retrofit
Retrofit Kit
Kit
Kit 19Y592
19Y592
19Y592
Motor replacement kit 19Y592 is used to retrofit
existing 5–10 gallon pail agitator part numbers
226086, 224572, 224571, 243340 that use rotary
vane air motor part number 101687.
1.
Relieve the pressure to the existing agitator.
Follow the
Pressure Relief Procedure, page 19
.
2.
Remove the cover from the pail.
3.
Remove the shaft/blade from the existing agitator
by loosening the set screw in the coupling. Clean
the shaft/blade.
4.
Remove the existing motor from the pail lid.
5.
Insert the new motor/sleeve into the existing
collar and tighten the set screw.
6.
Insert the shaft in the new coupling and tighten
the set screw. There is room to make slight
adjustments for length as needed.
7.
Install the cover on the pail.
8.
Install the air line. The agitator speed is adjusted
by adjusting the air regulator pressure.
Note
Agitator rotation direction is determined
by the supply port used on the air motor.
See
Air Regulator and Mufflers, page 8
.
NOTICE
NOTICE
NOTICE
Do not immerse or splash the bottom of the motor
in fluids. The bearing at the bottom of the motor
and the shaft may corrode.
Grounding
Grounding
Grounding
The equipment must be grounded to reduce the
risk of static sparking. Static sparking can cause
fumes to ignite or explode. To reduce the risk
of static sparking, the mounting cover and all
electrically conductive objects or devices in the
spray area must be properly grounded.
A ground wire and clamp are not included. For a
ground wire and clamp, order part number 237569.
To ground the agitator, do the following:
• For
For
For models
models
models 25C528,
25C528,
25C528, 25C533,
25C533,
25C533, 25M481,
25M481,
25M481, 26B618,
26B618,
26B618,
26B619,
26B619,
26B619, 26B630,
26B630,
26B630, 26B631,
26B631,
26B631, 26B632,
26B632,
26B632, and
and
and 26B633:
26B633:
26B633:
Connect one end of the ground wire (GW) to the
ground connector (GC) on the rim of the drum
cover. Connect the other end of the ground wire
to a true earth ground.
Figure 5 Ground Connector - Models 25C528,
25C533, and 25M481
• For
For
For models
models
models 25C529,
25C529,
25C529, 25C530,
25C530,
25C530, 25C534,
25C534,
25C534, 25C535,
25C535,
25C535,
25N881,
25N881,
25N881, and
and
and 25N882:
25N882:
25N882: Connect one end of the
ground wire (GW) to the agitator ground connector
(GC). Connect the other end of the ground wire
to a true earth ground.
Figure 6 Ground Connector - Model 25C529
3A4792G
15
