Connect Cables
Connect Cables
1. Turn off the 120/240 VAC alternator circuit
breaker (CB10).
Figure 2
2. Connect motor starter compressor power
cable to air compressor power junction box.
Remove junction box cover from air compressor.
Insert wires in cable end marked “AIR-CMP
MTR-STR” from starter box (12) through strain
relief and connect with wire nuts (39). See
Electrical Schematics, page 6
. Reassemble
cover.
24U079
WHT
BLK
GRN
GROUND
STUD
BLK 5
BLU 1
RED 8
YEL 4
AC-W1-W5
AC-W4-W8
AC-GND
CORD GRIP
16M826
CABLE 24U079
TO MOTOR STARTER
MOTOR JUNCTION BOX
WIRE NUT
#6
WIRE NUT
#6
ti23262a
Figure 3 Motor Starter Compressor Power
3. Connect motor starter compressor
overtemperature cable to compressor
over-temperature switch in enclosure (31).
WHT
BLK
16X011
AC-OT1
AC-OT2
CORD GRIP
260067
117625
CABLE 16X011
TO MOTOR STARTER
AIR COMPRESSOR OVER TEMPERATURE BOX
OVER
TEMPERATURE
SENSOR
16Y809
127581
ti23259a
Figure 4 Motor Starter Overtemperature Switch
4. Connect motor starter cable to the start/stop
switch enclosure.
WHT
BLK
RED
24U076
SS-1
SS-3
SS-2
SS-4
CORD GRIP
260067
117625
CABLE 24U076
TO MOTOR STARTER
AIR COMPRESSOR START STOP BOX
STOP
SWITCH
START
SWITCH
ti23416a
Figure 5 Start/Stop Switch Enclosure
5. Connect motor starter cable to air dryer
connector. See
Electrical Schematics, page 6
.
6. Route power cables from motor starter and air
compressor towards the electrical enclosure.
See
Cable Routing, page 11
.
4
332733A
All manuals and user guides at all-guides.com
