Roller Support Arm Installation
2
332355B
Roller Support Arm Installation
NOTE:
•
Install hose on reel prior to installation. See Hose
Installation instructions provided in the XD40 and
XD50 Hose Reels instruction manual.
•
Verify spring tension is set correctly. See Adjusting
Spring Tension instructions provided in the XD40
and XD50 Hose Reels instruction manual.
•
Adjust inlet orientation if needed. See Inlet Orienta-
tion instructions provided in the XD40 and XD50
Hose Reels instruction manual.
•
XD40 reels are shipped with the hose rollers bolted
near the reel mounting base, which is the proper
position for truck-mounted hose reels.
To install the accessory roller support arm:
1.
Use a large c-clamp (A) on the back of the hose reel
base to secure it to a flat surface (F
IG
. 1). Graco rec-
ommends placing a rag over the back frame to pro-
tect this surface from damage when the clamp is
tightened down.
2.
Unwind the hose so that it extends approximately 3
ft (0.9 m) beyond the roller plate and the latch is
engaged.
3.
Attach a c-clamp (B) to the back of the reel spool as
shown in F
IG
. 1 to help prevent the reel from unin-
tentionally becoming unlatched and spinning freely.
4.
Remove hose stop (e) (F
IG
. 2) and dispensing valve
(not shown) from end of hose.
MOVING PARTS HAZARD
Moving parts can pinch, cut or amputate fingers and
other body parts.
•
Keep clear of moving parts.
•
Do not operate equipment with protective guards or
covers removed.
F
IG
. 1
Never allow the reel to spin freely. Doing so causes
the hose to spin out of control, which could cause
serious injury if you are hit by the hose.
F
IG
. 2
A
B
e
