LD Pump Oil and Grease Drum Mounted System
3A1335K
17
Installing Follow Plate (grease models only)
1.
Relieve pressure
, page 6.
2.
Remove drum cover (16) by loosening thumb
screws (16a) (F
IG
. 24).
3.
Remove pump and cover from drum together and
place on a clean paper, cardboard, or clean shop
rags. DO NOT PLACE ON SHOP FLOOR.
NOTE:
It is not necessary to remove the pump from
the drum cover to remove the cover.
4.
If this is an existing installation, reach into drum and
pull up on the follow plate ring (15a) to remove the
follow plate (15) (F
IG
. 25). Place follow plate on a
clean paper, cardboard or clean shop rags. DO NOT
PLACE ON SHOP FLOOR.
Remove drum and install new one.
5.
Examine follow plate to make sure rubber grommet
(15b) is in place in center of the plate (F
IG
. 26).
6.
Set follow plate (15) on top of the fresh grease (F
IG
.
27). Remove air by pushing down on the follow plate
until the grease level is flush with the opening in the
middle of the follow plate (aa).
F
IG
. 24
F
IG
. 25
16a
15a
F
IG
. 26
F
IG
. 27
15b
aa
