Instructions
308939D
7
3.
Disengage the gun trigger safety latch
and engage the cable (402, H).
Vertical position of first or second gun:
1.
Loosen the post/arm clamp (6) and
move the gun up or down.
2.
Engage the trigger cable.Horizontal
position of second gun:
Method 1:
1.
Disengage the cable (402). Loosen the
clamps (405).
2.
Slide the second gun bar (404)
horizontally as desired, but be sure both
small clamps engage the second gun
bar.
3.
Tighten the clamps and engage cable
(402).
Method 2:
1.
Disengage the cable (402). Loosen the
post/arm clamp (6) and rotate gun out to
the side.
2.
Tighten the bolt and engage cable (402).
NOTE:
Use methods 1 and 2 together to
obtain the maximum distance of 33-1/2” (851
mm) between the center of two guns.
To mount guns on engine-side of the cart:
1.
For both guns, disengage the cables
(402, H) and engage the trigger safety
lever. See Fig. 4.
2.
Loosen gun holder knobs (93) and
remove the guns. Lay guns out of the
way.
3.
Remove knobs (G) on both carriage
clamps (D). The carriage bar (B) and
extension clamps (F) will drop down.
4.
Lift the front tire and rotate the carriage
180° under the cart and to the other side
of the cart.
5.
Position the carriage bar below the
carriage clamps (D). Align the holes in
the top of the extensions clamps (F) with
the holes in the carriage bar clamps and
install the knobs (G). See Fig. 3, Detail A.
6.
Loosen the post/arm clamps (6) and
rotate the gun arms (G) forward. Tighten
the clamps.
7.
Install the guns. See page 8. Note to
which gun and position on the dual gun
selector each of the cables (402, H)
goes.
8.
Route the hoses and cables carefully to
prevent kinking. Position the tip guards
and engage the cables (402, H).
