LL200 Compressor Installation
332230N
13
20. Use two carriage bolts (9), two washers (10), and
two nuts (17) in opposing holes (180 degrees apart)
to tighten the compressor to the mounting bracket
(4).
21. Slowly pull the starter rope to rotate until the two
M8x10 set screws appear in the set screw access.
Torque the set screws to 150-160 in-lb (16.9-18
N•m). Again, slowly pull the starter rope until the
single M5x8 set screw appears in the access and
tighten it to 37-42 in-lb (4-4.7 N•m).
NOTE:
Do
not
use ball end Allen wrenches, as they
may break and become stuck in the screws.
22. Remove two carriage bolts (9), two washers (10),
and two nuts (17) in opposing holes (180 degrees
apart), and rotate the compressor clockwise 90
degrees back to the upright orientation.
