m908 User Manual, Rev. G
section of this manual for details.
Analog Balanced Control Room Outputs:
DB25 Tascam pinout (See
). These outputs are defined in the setup menus for your Control Room speaker
system.
Analog Balanced CUE/WIDE Outputs:
DB25 Tascam pinout (See
).
Depending on your workflow these outputs are defined in the setup menus for your additional
surround/overhead speakers or CUE outputs.
Analog Balanced Stereo Control Room Output:
Male XLR, balanced, pin 2 positive, pin 3
negative and pin 1 ground. These outputs are defined in the setup menus for your Control Room
speaker system.
AES3 Digital I/O:
DB25 Tascam pinout, 110Ω (See
)
ADAT Lightpipe / TOSLINK Inputs:
In ADAT Lightpipe Mode these optical jacks provide
8 channels of audio data on each (at 44.1kHz and 48kHz). With ADAT S-MUX enabled 88.2kHz
or 96kHz sample rate audio channels 1-4 are received on OPTICAL input 1, while channels 5-8
are received on OPTICAL input 2. 176.4kHz and 192kHz sample rates are not supported over the
ADAT interface. In TOSLINK mode stereo signals up to 96kHz can be received on each
connector. See the
section of this manual for details on configuring the optical
input connectors.
SPDIF Digital Stereo Input:
RCA Phono jack, 75Ω. This input will receive PCM audio
signal sample rates from 44.1kHz to 192kHz.
USB Class 2 Audio Interface:
USB Type B jack. This interface is capable of 24 channel
input from host computer and 8 channel output to the host computer. Use a standard USB type A
-to- type B cable (included with your m908). The type A connector is to be plugged in to the
HOST computer and the type B connector to the m908 input. PCM 44.1kHz – 192kHz/24 bit is
supported. Please refer to
.
4.2.3 Optional ADC Module Connections
Analog Balanced 8 Channel Line Inputs:
DB25 Tascam Pinout (see
).
8 channel ADC module balanced inputs. See ADC option details in the
section of this manual.
Analog Balanced Stereo Line Input:
Female XLR, balanced, pin 2 positive, pin 3 negative
and pin 1 ground. Supplied with ADC Option Module. Allows for the connection of balanced
stereo sources to the ADC. Left channel is connected to ADC 1 channel 1 and Right channel is
connected to ADC 1 channel 2.
Analog Unbalanced Stereo Line Input:
RCA Phono. Supplied with ADC Option Module.
Allows for the connection of unbalanced stereo sources to the ADC. Left channel is connected to
ADC 1 channel 1 and Right channel is connected to ADC 1 channel 2.
Page 17 of 135
