grace design m906
owner’s manual
5
m906 audIo ConTrol unIT rear panel
TB MIC
5.1 CR OUT 2
5.1 CR OUT 1
5.1 INPUT 1
LS
RS
Sub
DC IN
5.1 DAC OUT
5.1 INPUT 2
REMOTE
TB SW
2 CH 2
L
R
GRACE DESIGN USA
2 CH 1
L
R
CUE IN
L
R
CUE OUT
L
R
CR OUT 2
L
R
CR OUT 1
L
R
Left
Right
Center
DIGITAL INPUTS / SYNC
AES3
S/PDIF
AES3 x 4
TOS
ADAT
THRU
GRACE DESIGN AT103 906 DAC
WORD CLOCK/
SUPERCLOCK
IN
1M
75
load
1
3
PUSH
2
1
3
PUSH
2
1
3
PUSH
2
1
3
PUSH
2
1
3
PUSH
2
1
3
PUSH
2
1
3
PUSH
2
1
3
PUSH
2
O
T
S
R
Q
L
M
G H
D
J
E
I
A
C
F
B
K
N
P
U
A
5.1 DAC OUTPUT This female DB-25 connector supplies 5.1 fixed level balanced DAC output sig-
nals, wired to the Tascam DA-88 standard pinout.
B
5.1 CR OUT #2 This female DB-25 connector carries the balanced analog Control Room Output #2
signals for connection to a 5.1 speaker system, wired to the Tascam DA-88 standard pinout.
C
5.1 CR OUT #1 This female DB-25 connector carries the balanced analog Control Room Output #1
signals for connection to a 5.1 speaker system, wired to the Tascam DA-88 standard pinout.
D
DC IN This 6-pin male XLR DC input accepts the supplied cable from the m906’s external power
supply.
E
WORD CLOCK/SUPER CLOCK THRU This BNC connector is used to pass an external Word Clock or
Super Clock reference signal through to another digital device downstream of the m906.
F
WORD CLOCK/SUPER CLOCK IN This BNC connector allows the m906 to receive an external Word
Clock or Super Clock source to be used as a reference for locking the m906’s internal clocks.
G
WORD CLOCK TERMINATION SWITCH This switch is used to properly terminate a connection from
an external clock reference source to the m906 Word or Super Clock input.
H
ADAT INPUT This Lightpipe connector provides an 8-channel input from an ADAT format digital
source. 44.1kHz and 48kHz sample rates are supported.
I
AES3 STEREO INPUT This female XLR connector is used to receive a stereo AES3 format digital
signal.
