9
1/4" away from the Stop.
Finger Tighten Only!
<
Set aside this assembly until Step10.
Step 9: Brace Assembly
Parts Needed:
2 - Braces
2 - 5/16" x 1 1/2" Hex Bolts
2 - 5/16" Large Flat Washers
2 - 1/4" x 3 1/2" Hex Bolts
2 - 1/4" Smaller Flat Washers
2 - Rectangle Nuts
2 - Diagonal Stand Assembly
<
Match the brace size with the pole size previously
assembled. (See top left)
<
Connect the two brace pieces together using the
5/16" x 1 1/2" hex bolts and washers as pictured.
<
**Important: Be sure the silver T-nuts (imbedded
in the brace) face outside so they are clearly
visible. (See middle left).**
<
Insert the bolts and washers as pictured. Only finger
tighten these bolts at this time.
<
Align the keyed end of the brace into the Diagonal Stand as
shown in picture (bottom left). Insert 1/4" X 3 1/2" Hex Head Bolt
through a 1/4" flat washer (smaller) and into the Diagonal Stand.
Place the Rectangle Nut into the slot so the hole lines up with the
bolt. Tighten the bolt into the Rectangle Nut until the
thbolt is
pulled all the way into the slot. This should be a good
solid joint. (Repeat for other side).
Step
10:
Poles/Ends Assembly to
Leg/Stand/Pivot Assembly
Parts Needed: 1 - Pole/End Assembly
2 - Leg/Stand/Pivot Assembly
4 - 5/16" Large Flat Washers
2 - Wing Nuts
2 - Lock Nuts
