8
opposite the cog wheel) into the shorter rail (end without the bolt--
see right ).
<
Connect the two rails using the metal connector sleeve.
Line up the holes in the sleeve with the holes in the raise.
Fasten the sleeve to the rails by putting a connecter bolt
though the smaller sleeve hole. Then place a cap nut
through the larger sleeve hole and thread it onto the
connector bolt. Completely tighten using the two Alan
wrenches provided. The black one is used with the bolt and
the silver one with the cap nut.
<
Repeat this process for the remaining two rails.
Step 8: Ratchet Stops and Poles with
Wheels to Mounting Ends
Parts Needed
6 - 1/4" Smaller Flat Washers
6 - Plastic Washers
6 - Nylon Lock Nuts
3 - Ratchet Wheel Stops
3 - 1/4" x 1 1/2"
Hex Head Bolts
<
Place a plastic washer on each
rail end (see middle right).
<
Position rail bolts (on ratchet
wheel end) through the three
holes of the Rright Pole
Mounting End as shown in
drawing. Thread the 1/4" Flat
Washers and the 5/16" Nylon
Lock Nuts onto the ends of
these bolts.
<
**All Lock Nuts must be left
loose enough that the poles
will roll freely.
<
Position the rail bolts on the
other end through all the holes of the
Left Mounting End. Thread the 1/4"
Flat Washers and the 5/16" Nylon
Lock Nuts onto the ends of these
bolts
<
Position the Ratchet Stops as
shown (right). Using
fingers--
not a tool!--
gently tighten the
1/4" X 1 1/2" Hex Head Bolts
through the Stops and into the
metal inserts. Only tighten so
that the Hex Bolt Head is about