Grabo NGH-V2, Manual

Page: 29 / 36

your feet to avoid twisting.
OPERATING THE GRABO® H V2
1. Install batteries [not included] (see INSTALLING /
CHANGING THE BATTERIES).
2. Slide the power ON/AUTO/OFF switch
Ⓒ
into the ON
position (motor continually runs) or AUTO position (automatic
start/stop function). When the vacuum level reaches -0.6 Bar
(- 6kPa) the pump will automatically stop. When the vacuum
level drops below -0.6 Bar (- 6kPa) , the GRABO® H V2 will
automatically restart the pump (when the pump is switched
on). The Battery bar indicator
Ⓓ
shows the amount of
available charge. NOTICE: If the battery bar indicator
Ⓓ
flashes red and green the batteries are low and need to be
replaced (see INSTALLING / CHANGING THE BATTERIES).
CAUTION: Using the GRABO® H V2 while the batteries are low
may result in injury and damage to the materials being lifted.
It is advisable to check the battery before using the GRABO®
H V2.
3. Position the GRABO® H V2 firmly against the surface of the
object you want to lift.
25