GPRINTER GP-1225D, User Manual

Page: 12 / 17

The printer configuration after the initialization will revert to the default values are as follows:
Parameter Default setting
Speed
Density
Gap
Direction
4inch/sec (101.6mm/sec),
10
0mm
203dpi
0
0
ON
ON
OFF
OFF
ON
ON
CLEAR
NOT CLEAR
Top left corner from printing direction
Printing content are placed on page from
top to bottom
Reference
SHIFT
OFFSET
SET TEAR
SET HEAD(Cover open detect)
Set PRINTKEY
SET REPRINT
SET KEY1(FEED)
SET KEY2(PAUSE)
CLEAR RAM
CLEAR FLASH
10
4.3.3 Printer Initialization
Printer initialization is used to clear DRAM and restore printer settings to defaults.
Please do the gap sensors sensitivity calibration after the printer initialization.
Please follow the steps below to initialize the printer:
1. Turn off the printer power.
2. Press and hold on the PAUSE button and FEED button, then turn on the printer
power. When the POWER indicator (blue light) dims and ERROR indicator (red light)
light, release both buttons. The printer DRAM is cleared and printer settings are
restored to defaults.
4.3.2 Dump mode
Please follow the steps:
1. Turn off the printer power.
2. Make sure the label roll is installed correctly and the printer top cover is closed.
3. Press and hold on the PAUSE button, then turn on the printer power. When the
POWER indicator (blue light) and ERROR indicator (red light) light simultaneously,
release the buttons. The printer is changed to Dump mode and print as below chart..
Printer will not print if data is not more than one piece of label, and need to press
FEED button to force the printer to print it out.
11
*********************
D
ir
e
c
t T
h
e
rm
a
l L
a
b
e
l P
ri
n
te
r