GP3D Root Plus User Manual
6
3.1.16 Click “START”, the platform will move along the direction shown
below. At this moment, you can observe the distance between the nozzle
and the platform. If it is equal all the time, the platform has been leveled.
Click “STOP” to stop the movement. If not, the platform needs to be
debugged in accordance with the following steps.
3.1.17
Click “X-” or “X+” to move the extruder to the central axis of the
platform.
3.1.18 Click “Y-” or “Y+” to move the platform back and forth to observe
whether the distance between the nozzle and the platform is equal all the
time.
3.1.19 If the distance is equal, enter the next step. If not, adjust the screw
fixing the platform till it is equal.
3.1.20 After determining the direction of Y-axis, move the platform to
make the extruder in the center. Click “X-” or “X+” to move it left and
right.
3.1.21 In the left and right movement, observe the distance between the
nozzle and the platform. If it is equal all the time, enter the next step. If
not, adjust the screw fixing the platform till it is equal.
Notice: the platform may be adjusted repeatedly from 3.1.15 to 3.1.21
to ensure equal distance between the nozzle and the platform. Once
confirmed, it does not need frequent adjustment.
3.1.22 “Height of Z-Axis (mm)” is the distance from the lowest position to
the highest position of the platform. This height is a key factor affecting
the success of the model printing. The printing height has been set before
the GP3D Root Plus leaves factory, and if the platform is adjusted or the
printing height changes after a period of time of use, fine-tune this value.
During printing, if the model sticks to the hotbed panel tightly and it is
difficult to remove the model, you can click “-▼”, and the figure in the
display frame will be reduced by 0.1mm. If the model sticks to the hotbed
panel loosely, the model tends to have warping edge or fall off, click “+▲”,
and the figure in the display frame will be increased by 0.1mm. After
adjustment, click “SAVE”, and the model will be printed at this height next
time.