GP3D Root Plus User Manual
3
II. Preparations
2.1 Out-of-box audit
Please check the product after the box is open, and in case of any
surface scratch or damage, please contact local dealer or our after-sales
service.
Check the accessories in accordance with the product packing list, and
in case of any missing, please contact local dealer or our after-sales
service.
2.2 Accessories assembly
2.2.1 Open the toolkit, as shown in the following figure.
2.2.2 Assembly of spoon holder: take out the two screws in the middle of
the right side of the GP3D Root Plus and fix the spoon holder with the
screws. Note that the rib is on the upper side.
2.2.3 Assembly of filament card: take out the screw at the back of the
upper right side of the GP3D Root Plus and fix the filament card with the
screw.
2.2.4 Fixation of hotbed panel: fix the hotbed panel on the build plate
with four clamps.
2.2.5 Preparation of filament rod: The filament free end must be cut to be
flat. Please keep it straight as well.
2.2.6 Hang the feed disk on the spoon holder and put the filament
through the filament card.
2.2.7 Pass the filament through Teflon tube
2.2.8 Power on: plug the output end of the power adapter into the power
interface on the GP3D Root Plus.