Device Description HG G-19370-B/HG G-19380-B | English, Revision 03 | Date: 05.05.2020
11
Mounting – Chapter 3
3
Mounting
3.1 Guide Wire
The guidelines for the ground installation of guide wires are explained in a separate
document. You can download the PDF file from the following address (section Ap
-
plication Examples and Downloads):
http://www.goetting-agv.com/components/inductive/introduction
3.2 Energy Track
An existing ground installation for the contact-less inductive energy transmission is
used. The inductive guidance sensor is available in different variants for common
energy track installations, s. Table 2 on page 7.
3.3 Inductive Guidance Sensor
3.3.1 Requirements
Additional magnetic fields close to the sensor can affect the system characteristics.
Therefore:
The limit value for the magnetic field of e.g. transverters/engines/wire connec
-
tions at the position of the inductive guidance sensor is circa 0,01 A/m.
3.3.2 Mounting on the Vehicle
Figure 3
Casing dimensions and mounting drill holes (all variants)
156,5
140
69,
7
S 2
T
ST1
ST3
M12 circular connector BUS 1
Di
re
ct
io
n
o
f t
ra
ve
l
M12 circular connector BUS 2
Mounting Drill Holes ø 5,3 mm
depending on the bus type
depending on the bus type
M12x1 circular connector
8 in
-p (male)
A-coded
13
20
16
31
26,
5
Lower edge of the device
