Gotharman deMOON, User Manual

Page: 11 / 38

11
The Edit pages
NOTICE: The edits you do, are not automatically stored in memory. If you would like to keep your
creation, you wil have to SAVE the pattern. How to do that, are explained later in this section.
How to enter the edit pages from the pattern select page:
If the cursor is not blinking, push the cursor(click)value encoder, so the cursor is blinking. Rotate
the cursor(click)value encoder until the cursor is located under ”Edit”. Push the cursor(click)value
encoder. Now this screen should appear:
and the cursor are blinking. If you want to exit back to the pattern/sound select screen, rotate the
cursor(click)value encoder so the cusor locates under eXit, and push it.
If you, on the other hand, wants to start editing some sounds and/or sequences, make sure that the
cursor is located under the number, and push the cursor(click)value encoder. Now the cursor will
stop blinking, and by rotating the cursor(click)value encoder, you can now select among various
edit pages. Pushing the cursor(click)value encoder again, enters the edit page.
Inside an edit page, it might look like this:
When you enters an edit page, the cursor are blinking. By placing the cursor under the number in
the upper left corner of the display, and pushing the cursor(click)value encoder you can select
among various edit pages in the selected edit group. By placing the cursor under the ”X” and
pushing the cursor(click)value encoder, you will exit to the edit page group select page.
The two parameters shown in the left and in the middle of the display are changed by rotating the
edit1 and edit2 knobs. The parameter to the right is changed by moving the cursor to it, and use the
cursor(click)value encoder.