Gossen MetraWatt SMARTCONTROL ECS, Installation Instructions Manual

Page: 10 / 42

10 GMC-I Messtechnik GmbH
5. Installation
5.1. Before Installing
Note:
Please check to make sure that the SMARTCONTROL and all included accessories are complete and
undamaged. The freight forwarder must be notified without delay in the event of transport
damage. The device may not be placed into operation in the event of damage.
5.1.1. Scope of Delivery for SMARTCONTROL Standard
The following is included in scope of delivery:

SMARTCONTROL

Installation instructions

Installation report

CD with SMARTCONTROL Manager software and documentation

RJ-45 crossover patch cable for connecting the SMARTCONTROL to a PC
The PC can also be connected by means of an additional module via analog modem, ISDN, GSM or Bluetooth. See
also section 8.2. , “Communication Modules”.
5.1.2. Scope of Delivery for SMARTCONTROL IP-65
The SMARTCONTROL is delivered in a control cabinet which fulfills IP 65 requirements (optionally lockable, lock
meets IP 34). The SMARTCONTROL consists of a single PCB system, a power pack, a circuit breaker and various
attachable components. In addition to this, optional devices (e.g. M-Bus, fieldbus) can be secured to the
integrated mounting rail or inserted into available slots on the PCB (e.g. socket modules or memory expansions).
Heavy duty cable glands (1 ea. M25, 4 ea. M16) are provided at the bottom for cable entry. The control cabinet is
available in other sizes upon request.
5.2. Operating conditions
Tip:
Carefully select the location at which the SMARTCONTROL will be installed. Don’t forget that a
230 V AC mains connection is required for operation of the SMARTCONTROL and, if applicable, that
communication facilities must be provided for remote read-out.
Recommended installation height: at least 50 cm, and not more than 150 cm from the floor to the
bottom edge of the cabinet or housing. The wall to which the device is mounted must be flat, dry and
sturdy.
Furthermore, the location of sensors, transducers and other devices which will be connected to the
SMARTCONTROL must also be taken into consideration in order to minimize wiring expenses.