1
Fill
distilled
water into a glass jar (please do not
use tap water, can be harmful to health!).
2
Connect the power supply to the goSilver device.
Insert the plug as far as it will go into the socket.
3
Insert the silver electrodes as far as they will
go into the sockets on the bottom of the unit.
4
Select the desired water quantity using the rotary
switch (the rotary switch must engage noticeably
horizontally or vertically, the respective number (0-3)
must be visible in the section), and the desired ppm
with the SELECT button. The corresponding ppm LED
(light-emitting diode) lights up.
5
Finally, place the unit with the electrodes ahead on
the glass vessel. The electrodes dip into the water.
As a precaution, secure the cable of the power sup-
ply unit with tape on the table and make sure that
the device can not fall into the container.
6
Press the START button. The electrolysis starts. The
corresponding ppm LED flashes rapidly. After a whi-
le, the polarity LED will show weak and then increa-
singly brighter the cyclic alternation (approximately
every 15 seconds) of the current direction.
7
When the desired concentration is reached, the
device switches off automatically. A 3 second beep
sounds, the corresponding ppm LED flashes signi-
ficantly slower, signaling the end of the electrolysis
process.
8
The last set concentration remains stored in the
device even when the device has been switched off.
If you want to produce a silver solution with the same
concentration again, only press the START button.
9
After use, wipe the silver electrodes with
a dry cloth. Protect the produced silver
solution from direct sunlight.
SELEC
T
INDIVID
UAL
100ppm
/250m
l
50ppm/2
50ml
25ppm/2
50ml
Si l v
go
Silver
®
