Gorilla Pioneer Peak, Manual

Page: 20 / 97

RAMP SIDE
BOARD FIRST
LARGE HOLES SHOULD BE CLOSEST TO THE FLOOR
2 X 4 X 18-3/4"
RAMP SUPPORT
2-1/2"
WOOD SCREW
2 X 4 X 96"
INSTALL THIS BOARD SECOND
INSTALL THIS
1"
4"
44 34 "
CHECK TO SEE IF THESE TWO HOLES
ARE DRILLED THROUGH COMPLETELY
IN THE RAMP SIDES. IF THEY ARE NOT
DRILLED ALL THE WAY THROUGH THEN
CAREFULLY REAM THEM OUT WITH A
3/8" DRILL BIT.
ROUND END
STEP 16: CLIMBING RAMP
1: LAY OUT THE 2 X 4 X 96" RAMP SIDE BOARDS MAKING SURE THE LARGE HOLES ON TEH ENDS ARE CLOSEST TO THE
FLOOR.
2: FIRST PLACE ONE 2 X 4 X 18-3/4" RAMP SUPPORT BOARD AT THE SQUARE END OF THE 2 X 4 X 96" RAMP SIDE
BOARDS. OFFSET THE BOARD 1" FROM THE END. FASTEN THE RAMP SUPPORT BOARD TO THE RAMP SIDE BOARDS
WITH TWO 2-1/2" WOOD SCREWS PER SIDE.
3: SECOND PLACE ONE 2 X 4 X 18-3/4" RAMP SUPPORT BOARD AT THE ROUND END OF THE 2 X 4 X 96" RAMP SIDE
BOARDS. OFFSET THE BOARD 4" FROM THE ROUND END. FASTEN THE RAMP SUPPORT BOARD TO THE RAMP SIDE
BOARDS WITH TWO 2-1/2" WOOD SCREWS PER SIDE.
4: PLACE THE REMAINING 2 X 4 X 18-3/4" RAMP SUPPORT BOARD ACROSS THE RAMP SIDE BOARDS IN THE MIDDLE,
44-3/4" FROMT HE SQUARE END AND FASTEN WITH TWO 2-1/2" WOOD SCREWS PER SIDE.
NOTE: CLIMBING RAMP TO BE INSTALLED INSTEAD OF LADDER ON THIS MODEL. THE LADDER PARTS ARE INCLUDED
IN THE PACKAGE BUT ARE NOT USED.
58