5/16" X 4-1/2" HEX BOLT
WITH 5/16" WASHER
STEP 41: RADRIDE PANEL WALL
1: LOCATE THE 4 X 4 X 37-5/8" RADRIDE POST, INSERT A T-NUT INTO THE PRE DRILLED HOLE.
2: MOUNT THE RADRIDE POST ON TOP OF THE DECK SPACER AND LINE UP THE PREDRILLED HOLE WITH THE RADRIDE
TOP PANEL BOARD CENTER HOLE. FASTEN USING A 5/16" X 4-1/2" HEX BOLT AND 5/16" WASHER.
3: PLACE THE 2 X 6 X 21-1/2" RADRIDE EXIT BOARD ONTO THE REAR OF THE FORT. THE HOLES SHOULD BE OFFSET UP.
LINE UP THE TOP HOLE OF THE EXIT BOARD WITH THE HOLE IN THE END REAR CORNER POST. FASTEN THE TOP HOLE
TO THE CORNER POST WITH A 5/16" X 4-1/2" HEX BOLT WITH 5/16" WASHER. MAKE SURE THE RADRIDE EXIT BOARD IS
HORIZONTALLY LEVEL AND THEN FASTEN THE BOTTOM HOLE WITH A 5/16" X 3-1/2" LAG SCREW AND 5/16" WASHER.
4: MAKE SURE THE 4 X 4 X 37-5/8" RADRIDE POST IS VERTICALLY LEVEL AND FLUSH TO THE EDGE OF THE 2 X 6 EXIT
BOARD. INSERT TWO 3" WOOD SCREWS FROM UNDERNEATH THE DECK THROUGH THE DECK SPACER INTO THE 4 X
4 RADRIDE POST.
3"
WOOD
SCREWS
(TWO)
NO
HARDWARE
WOOD SCREWS
LAG SCREW
#8 X 3"
2 X 6 X 21-1/2"
WITH 5/16 WASHER
T-NUT
FLUSH
RADRIDE POST
RADRIDE EXIT BOARD
USED HERE YET.
5/16" X 3-1/2"
4 X 4 X 37-5/8"
5/16" X 4-1/2"
HEX BOLT
WITH 5/16" WASHER
74
