Gorenje WCIU2090A1, Detailed Instructions For Use

Page: 28 / 60

28
7. Guide the door onto the upper hinge pivot and manoeuvre the lower part of
the door and pivot plate onto the lower hinge. Align the pivot plate holes with
the hinge plate holes.
8. Reinsert the two screws that you removed in step 1 and tighten them. Check
that the door sits level with the appliance. If not, the pivot plate offers some
adjustment - loosen the screws you have just tightened and adjust the door as
necessary.
Pivot plate
Screws (2pcs)
Bottom left hinge
Fig. 13
Fitting the plinth
The plinth/grille for this appliance comes packaged inside and can be fitted if
desired. Follow these steps to do so:
1. Locate the plinth (packaged inside the appliance)
2. Remove the four screws from (two on each side of) the plinth section, but
take care to support both sections to prevent the adjustable section from
falling away. Remove the adjustable front section and place this somewhere
safe.
3. With the help of another individual, make sure the wine cooler is secure and
tilt it backwards to gain full access to the area below the door. Make sure
that the door is kept closed at all times during this process in order to avoid
damage to the door and appliance.
4. If present, remove the two screws shown by arrows and marked as 'A' in Fig.
14. Then, locate the four black fitting screws. These are packaged inside the
appliance with the door reversing hinge.
5. If present, remove the screws shown by arrows and marked as 'B' in Fig. 15.
These are not needed.
6. Offer up the plinth, ensuring it is the same way up as per Fig. 16. Then, using
a (magnetic tipped) screwdriver, insert two of the black fitting screws through
the oval access holes (shown in Fig. 16) and tighten them.
7. Install a (black fitting) screw into each of the two lower holes (shown in Fig.
16). This will help to secure the plinth to the underside of the wine cooler.