38
TROUBLESHOOTING TABLE
350135
Failure
Possible cause
What to do...?
The machine does not work.
• Machine is not powered.
Check if:
• power in the socket,
• the fuse is OK,
• plug is in the socket.
Water is leaking from the
machine.
• Filter is not tightly screwed
in.
• Inlet pipe is not tightly
screwed to the machine or
to the water faucet.
• Outlet pipe fell to the floor.
• Tighten the filter properly.
• Tighten the inlet pipe.
• Affix the outlet pipe to the
drain.
The machine moves during
operation.
• The machine is not properly
levelled.
• Transport brackets are not
removed.
• Level the machine with the
adjustable legs.
• Remove transport brackets.
The machine vibrates during
the spin.
• Unevenly distributed
laundry, especially with very
small quantities (for ex. only
the bathrobe).
• This is normal, the machine
will reduce the RPM if
vibrations are too strong.
Wash larger quantity of
laundry.
Excessive foaming during
washing.
• Excessive measure of
detergent.
• Use washing powder
according to the instructions
by the producer and
according to the water
hardness and soiled laundry.
Use only detergents for
machine washing.
Laundry is not properly
spun. No failure is reported.
• The machine switched on
the UKS* function. Because
of bad laundry balance, the
machine has automatically
reduced spin RPM.
• The machine operates
normally. Wash large and
small pieces of laundry
together.
Greasy wads appear on the
laundry.
• Too little detergent (laundry
was very greasy).
• Wash the laundry again. Add
more detergent for such
soiled laundry, or use liquid
detergent.
Laundry is stained after
washing.
• You used liquid detergent
or detergent for coloured
laundry which does not
contain whitener.
• Unsuitable program has
been selected.
• Use the detergent containing
whitener.
• Use special stain removers.
White powdery residues on
the laundry.
• It is not the consequence of
bad rinsing, but because of
neo-phosphate detergents
containing non soluble
components (zeolites)
for water softening.
Such substances may be
deposited upon the laundry.
• Immediately rinse the laundry
once again.
• Use liquid detergents which
do not contain zeolites.
• Try removing the residues
with the brush
Detergent residues in the
dispenser.
• Low water flow pressure.
Some detergents may stick
to the dispenser rather hard
if it is wet.
• Clean the inlet pipe filter net.
• Wipe the dispenser prior
loading detergent.