36
INERRUPTING AND CHANCHING
THE PROGRAM
350135
If a power failure occurs when the drum is still full of water, be
careful not to open the door before you pump the water out.
(see Programs/partial programs: Spinning/pumping).
Manual (physical) termination
The program can be cancelled / terminated
by rotating the program selector dial (1) to
the position. “0FF” position.
If there is water in the machine, select the
additional program (spin + (pump
)
) key
(3).
Personal settings
You can change the original settings of
each program. Once you select a washing
program and additional functions, you may
save (store) such combination by pressing
the START/PAUSE key and keep it pressed
for 8 seconds.
When the program is saved, all lights will
flash.
The program will remain stored until it is
changed using the same procedure.
PAUSE KEY
The program can always be stopped by
pressing the START/PAUSE. If there is no
water in the drum, the door can be opened
after a while; otherwise, the door cannot be
opened. To resume the program, press the
START/PAUSE key.
FAULTS
In case of a fault, the program will be
interrupted.
This is indicated by flashing signal lights
(see chapter Troubleshooting).
Power failure
At electric cutout the program is
interrupted. When the power supply is re-
established, press the START/PAUSE key to
resume the washing program.
Opening the door (Temporary
interruption/ Permanent suspension -
change of program)
Washing machine door may only be opened
if the water level is sufficiently low. If it is
not, the water must first be pumped out
of the machine. Use the additional water
pumping or spinning program).
