Instructions for use, installation and connection
58
Troubleshooting guide
Any unskilled attempt to repair the appliance is extremely
dangerous as it might cause electric shock and short circuit. To
avoid such injuries any repairs may be performed only by
qualified personnel, or after sales service.
Before attempting any repairs disconnect the appliance from
the mains by removing the fuse or unplugging the mains lead
from the mains socket.
Note!
There are, however, some minor faults which may be easily
removed by the user, in accordance with the instructions that
follow.
Important!
If the malfunction of the appliance was caused by the
improper use
, the service visit during the warranty period is
not free of charge
.
Following are some simple advice how to repair minor
faults:
Program clock indicates faulty values or switches on and
off intermitently…
In case of program clock malfunction switch the cooker off,
disconnect it from the mains for a few minutes (remove the
fuse or switch off the main switch), then reconnect it to the
mains and set the correct daily time.
Program clock display is flashing…
There was a power failure, or the cooker had been connected
to the mains for the first time. All settings are erased. Set the
correct time of day to be able to activate the oven.
After operating in automatic mode, the oven switches off, the
display indicates time, and the beep is heard. Take the food
from the oven, set the temperature selection knob and the
mode knob into their original positions. Select the "Manual
mode", and use the oven in a conventional mode (without
programming).
Signal lamp does not turn on....
•
are all the required switches properly activated?
•
is the mains power fuse burned?
•
is the temperature regulator properly set?
Fuses often burn out...
•
Call the serviceman or your electrician!
Oven illumination is not on....
•
Exchange of oven bulb is described in the section
"Replacement of parts".
Oven does not heat up...
•
is the mains power fuse burned?
•
is the temperature regulator set correctly?
Baking results are disappointing...
•
did you remove the grease filter?
•
did you follow the instructions and warnings from the section
"Baking"?
•
did you strictly follow the information from the Baking table?
Burners do not burn uniformly…
•
Gas serviceman should check the gas settings!
Burner flame suddenly changes, burners require excessive
ignition time…
•
Assembly the burner components correctly!
Flame goes off immediately after ignition…
•
Keep the button pressed somewhat longer.
•
Push firmly once more before releasing the button.
Burner grid has changed color in the burning area…
•
This is a normal consequence of high temperature; clean the
grid with metal cleaner.
Electric ignition of gas is malfunctioning, burner covers
are dirty…
•
Carefully clean the gap between the ignition spark and the
burner.
•
Clean the covers with a metal cleaning agent.
Replacement of parts
The oven light bulb casing is under tension. Danger of
electric shock!
Before replacing the oven bulb switch off the cooker and cut it
from mains by removing the mains power fuse or disconnect
the protective device.
Remember that the bulb is regarded as consumption material
and is not covered by the warranty.
Other accessories
Oven grid, biscuit tray, etc. may be ordered from the service
center. When ordering please quote the code and the type or
model of the appliance.
Hotplate control knobs are removed by pulling them outwards
and replaced by pushing the new ones back in place.
Oven light bulb
The bulb for replacement
should meet the following
specifications:
E 14, 230 V, 25 W, 300°C.
Unscrew the glass cover by
turning it counter clockwise,
and replace the bulb.
Screw the glass cover back in
place.
Glass cover of side lamp can
be easily removed by the
screwdriver (see the drawing).
Remember that the bulb is
regarded as consumption
material and is not covered
by the warranty.
