50459
7
• The appliance may only be connected by an authorized skilled technician.
• Electric system protection should comply with all relevant regulations.
• The connection clips can be accessed when the connection clip covers are opened /
removed.
• Before connecting the appliance, make sure the voltage indicated on the rating plate is
consistent with the voltage in your home circuit.
• The rating plate with basic information is attached on the lower side of the hob.
• The electric circuit should also include an omnipolar switch that will separate the
appliance from the mains, if required, with at least 3 mm of distance between contacts.
Suitable devices include fuses, current protection switches, etc.
• The connection should be selected according to the installation possibilities with regard
to current and fuses.
• Given the protection from the risk of fi re, appliances of this type may be installed in
a worktop next to a piece of kitchen furniture that is taller than the appliance (when
installed); however, in this case, a kitchen furniture not higher than the cooking hob must
be installed on the other side, adjacent to the appliance.
• The current conducting and isolated parts must be protected from any possibility of
direct contact.
ATTENTION!
• Before any manipulation with the appliance (other than its regular use), disconnect it
from the power mains. The appliance should be connected according to the relevant
scheme (diagram), subject to the network voltage. Connect the earth (PE) wire to the
clip indicated with the earth /ground symbol.
• The mains cord must be fed through the fastening clip / strain release device which
protects it from being pulled out accidentally.
• After connecting the appliance, turn on all cookers for approximately three minutes to
check their operation.
Important warnings
16
CONNECTING THE APPLIANCE TO
THE POWER MAINS
