Placing the dishwasher
The dishwasher is intended for
freestanding installation, but can also be
installed under a worktop.
Adjust the height and slide the
dishwasher into place
24 mm
Freestanding
1 Make sure the area on which the
dishwasher is to be installed is firm.
Adjust the dishwasher's height using
the four feet so that the dishwasher is
level. The dishwasher may lean no
more than 5 mm.
2 Once the feet are properly adjusted,
tighten the anti-tip feet firmly against
the floor.
Anti-tip feet
Built-in
1 Start by measuring the height from the
floor to the bottom edge of the worktop.
2 Measure the height from the floor to the
top edge of the dishwasher.
3 Adjust the dishwasher's feet by turning
them clockwise to raise or anticlockwise
to lower the machine.
4 Check that there is an air gap of at least
3 mm between the underside of the
worktop and the top edge of the
dishwasher.
5 Slide the dishwasher into place.
• Pull through the drainage and supply
hoses when the machine is slid into
place.
• Check that the hoses have no kinks
or sharp bends, and check that there
is nothing that can damage the
hoses.
• Check that the machine is installed
such that the door opens freely,
otherwise door lock functionality may
be disrupted.
6 Make any final adjustments to the front
feet (the dishwasher may lean no more
than 5 mm).
7 Once the feet are properly adjusted,
tighten the anti-tip feet firmly against
the floor.
The dishwasher can also be installed in a
recess without its worktop. See Remove
dishwasher worktop.
27
