21
Hob controls
CONTROL PANEL
During time period, when the sensors are adapting to the
external conditions:
x
Do not put objects on their surface as the failure mode could
be activated.
x
Keep always the sensors' surface clean.
x
Do not expose them to excessive light, as for instance
halogen lamp or direct sunlight etc.
The sensors could be calibrated incorrectly at unobserving of
these conditions and a failure message appears on the
display (see the table). A correct calibration is provided
automatically after removing of failure reason.
CALIBRATION OF
SENSORS
WARNING!
x
The sensor control is activated by touching a finger to
appropriate symbol on glass ceramic hob. Therefore keep the
control panel clean and dry.
x
The sensors do not react to dark mat colors (do not use black
gloves). Do not put objects on the hotplate control panel.
x
Prevent all unwished switching on appliance, for instance with
pets!
SWITCHING ON OF
HOTPLATE
Simply press the sensor B (power switch). The symbol
„O“
or
„H“
appears on both displays and the symbols for activation of
cooking zone
„N“
are blinking. If you would not provide a
following selection up to 10 seconds, the hotplate would be
switched off automatically.
SWITCHING ON OF
COOKING ZONE
Press the sensor "L" of chosen cooking zone up to 10 seconds
after switching on of hotplate. The corresponding activation
symbol
„N“
of cooking zone will light constantly, the other
„N“
symbols go off. We should now provide the selection of required
capacity level (1-9) and this help of
„+“ a
nd
„
-
“
sensors and up to
8 seconds.
SELECTION OF HEATING
CAPACITY LEVEL
WITHOUT PREHEATING
FUNCTION:
Activate the cooking zone (the
symbol „N“
is shining
permanently) and choose the capacity level up to 8 seconds.
REMARK:
When setting up the capacity level with help of sensor for
„
-
“,
then the selected capacity level and the symbol "A" will
alternately blink during 8 seconds. The finally chosen capacity
level will be permanently displayed on the display after elapsing
of this time.
