Gorenje D62225, Instructions For Use Manual

Page: 11 / 20

141
186
next press of the same button the program is resumed where it
had been interrupted.
Changing the program or the functions
If you wish to change the drying program or the additional
functions during the drying procedure, move button (A) to the
position “0”, select new drying program or additional functions
and con
fi rm the new selection by pressing the START /PAUSE
button.
Door opened
If the door is opened during the drying process this will pause the
operation. The (I) or (H) LEDs will
fl ash, depending on the drying
process stage. When the door is closed, the drying process
resumes only after the
START /PAUSE button (D) is pressed. The
(I) or (H) LED stops fl ashing.
• Power failure
If a power failure occurs during the operation of the dryer, ((I)
or (H) LED fl ashes, depending of the drying process stage),
press the START (D) button to resume the program from
where it was interrupted (the LED stops
fl ashing).
• Water container is full
On a condensation dryer the (E) LED is on, indicating that the
water container is full, and the drying program is suspended
((E) and (I) or (E) and (H) LED’s are
fl ashing, depending on
the drying process stage). When the container is emptied,
press the START button (D) to reactivate the drying program.
The (I) or (H) LED is on again.
• Drum lamp
The drum is illuminated when the appliance door is open. If the
door is open for more than 5 minutes and no changes to the
settings have been made, the lamp goes off.
Special functions Special functions
11