Gorenje D62225, Instructions For Use Manual

Page: 10 / 20

141
186
• Drying process is turned on by pressing the START /PAUSE
button (D); the (I) LED lights.
• If you turn the program selector jog during the drying process,
settings do not change, except at the position “0”, whereby the
program is suspended.
• When the set moisture level is reached, the cooling process
starts; the (I) LED goes off and the (H) LED is on.
• If the ventilation program is selected (see drying programs
table) the (I) LED is on throughout the entire program.
• Cooling off period lasts 10 minutes; LED (H) is on.
• Program is suspended if the drum sensor fails to detect
laundry in the drum.
• The anti-crease program is active at the end of program and
remains active for 1 hour (drum occasionally spins around).
• If you open the drum door after the drying cycle had been
completed, the anti-crease program is ended.
- End of drying procedure
At the end of the drying procedure the (G) LED fl ashes,
indicating that the drying program has ended. Signal
LED’s clean the
fi lter (F) and drain the container (E) are
on (only for condensation type of dryer).
• Open the dryer door by pushing the left-hand side of the door
towards the appliance.
• Remove the laundry from the dryer.
• Turn the appliance off by turning the jog selector (A) to the
position “0”.
• Clean the lint fi lter (see chapter on Cleaning and
Maintenance).
• Close the dryer door.
• Empty the water container (this applies for condensation
dryers only - see Cleaning and Maintenance) and replace it
back to its slot.
• Pull the power lead from the socket and cut the power supply
from the mains.
•
By the user
After drying be careful when extracting laundry from
the appliance, as it may be hot!
Suspending the operation by pressing the START/PAUSE
button.
In case you press the START/ PAUSE button (D) during the
drying procedure, the drying program is suspended, and with the
Drying procedure Drying procedure
Interruptions Interruptions
10