Gorenje Classico series, Instructions For Use Manual

Page: 48 / 56

425555
The appliance may only be connected to the power
mains by an authorized service technician or a registered
electrician! Incorrect connection may result in damage to
or destruction of respective parts of the appliance; in such
cases, the warranty is void.
‘’ The appliances are suitable for photovoltaic electrical
power under the condition that electrical voltage will
be 220VAC - 240VAC with semi tonic frequency 50z
in order the appliance to operate properly (alternative
a generator can be used with the same technical
characteristic).’’
• Open the connection clip using a screwdriver, as indicated
on the fi gure on the cover.
• The voltage (230V against N) in your home network must
be checked by an expert using appropriate equipment!
• The connection bridges must be placed in compliance with
the network connection!
• Before connection, make sure the voltage on the rating
plate is consistent with the actual network voltage.
• The length of the power cord should be at least 1.5 meters;
thus, the appliance can be connected before it is pushed to
the wall.
• The length of the power cord should be adjusted in such
way that in case of pulling load on the cable, the ground
wire is strained later than the voltage wires.
Procedure
• Use a screwdriver to open the cover of the connection
terminal on the back of the appliance. Release the
two clips as indicated on the cover of the connection
terminal.
• The mains cord must be inserted into the strain release
device which protects the cable from being pulled out.
If the strain release device is not installed yet, install it in
such way that it gets stuck in the connection terminal
housing at one end.
• Then, connect the appliance according to the
instructions indicated on the fi gures. If network voltage
is diff erent, the connection bridges should be replaced.
• Firmly fasten the strain release device and close the
cover.
NOTE:
Connection bridges are stored in the slots provided
in the connection terminal. The connection screws are
already open and do not require additional releasing.
When fastening the screws, they will click, which indicates
that the screw must be fastened all the way.
Electrical connection
48