Gorenje Classico series, Instructions For Use Manual

Page: 38 / 56

425555
• To replace the door, observe the reverse order.
Note: To replace the glass, make sure the markings
(crescent) on the door and the glass are aligned
(Figure 4).
REMOVING AND REPLACING THE OVEN DOOR WITH A
SINGLE-AXIS HINGE
Conventional closing
• Fully open the oven door and rotate the stoppers all the
way back – applies to conventional door closing (Figure 1).
• Slowly close the door until the clips are pressed against
the supports / seats. At approximately 15° (relative to the
closed door position), pull the door slightly upward and
pull them out of the both hinge supports on the appliances
(Figure 3).
• Replace the door in the reverse order. Insert the door under
an angle of 15° into the hinge supports at the front side of
the appliance and push them downwards and to the front
until they slide into their supports / seats.
• Then, completely open the door and rotate the attachment
clips back to their initial position. Slowly close the door and
check, if they close properly. If the door does not open or
close correctly, make sure whether the hinge notches are
correctly placed in their seat hinges.
Attention
Always make sure the hinge attachment clips are fi rmly
seated in their supports when installing the door. If this is not
the case, the main hinge that is operated by a strong spring
may be released any time while installing or removing the
door. Risk of physical injury.
Figure 4
fi gure 1
fi gure 3
38