EN 3
knob towards the panel to a limit position. High
voltage ignition device starts firing the burner.
After firing the burner hold the knob pressed to a
limit position to the panel for about 3 seconds till
the flame sensor heats up.
Release the knob and check whether the burner
is on.
If the flame dies after releasing the knob, repeat
the ignition procedure.
1. OFF
2. Maximum power
3. Saving
SHUTTING THE HOB BURNERS OFF
Turn the selected knob to the “OFF” position and
check whether the flame is extinct
CAUTION
Before opening the hob lid any spilled liquid must be
removed from the lid surface.
Do not close the hob lid if the burners are still hot!
COOKING
Use low and wide cookware for preparing food on
gas burners. Make sure the burner flames heat the
dish bottom and do not go beyond its rim.
The appliance is fitted with different size burners.
For optimum (economical) consumption of gas use
the recommended cookware bottom diameters:
- small
burner from Ø 120 to Ø 160 mm,
-
medium burner from Ø 160 to Ø 220 mm,
-
large burner from Ø 220 to Ø 280 mm.
OVEN INSIDE
Oven is fitted with three level side guides for
inserting the grid.
There is an upper heating element with grill element
inside of the oven. The lower heating element is
situated under the oven bottom. In the rear part of
the oven
– under the distributing cover – the circular
heating element and the ventilator are situated.
OVEN SWITCHING ON AND OFF
Select the desired function of the oven by the oven
function knob. The knob can be turned in both
directions. Set the temperature for food preparation
by the thermostat knob within 50-250
°C.
You must turn right by the thermostat knob - setting
higher
temperature.
Turning
back,
the
set
temperature is reduced.
Forcible overturning of the zero position will lead
to the thermostat damage!
WARNING!
Do not cover oven bottom with aluminum foil, place
on bottom oven tray, baking pan, container, food or
food products. Coverage causes local overheating of
the bottom surface of the bottom of the furnace and
the furnace can be irreparably damaged by this
behavior.
INSERTING OF GRID IN THE OVEN
OVEN FUNCTIONS AND APPLICATIONS
Oven illumination being on in setting up all the oven
functions.
Oven is heat by top and bottom heating element.
The thermostat can be set to a temperature within
50-
250°C.
Grilling by infrared radiation. The temperature
selector is set to the maximum position.
Grilling assisted with oven fan.
Temperature inside the oven is higher towards the
top. The temperature selector is set between the
150-250
°C range.