Gorenje Plus GIS64XC, Instructions For Use Manual

Page: 26 / 36

454509
SYMPTOM POSSIBLE CAUSE SOLUTION
A fuse blows as soon as the
hob is switched on. The hob has been wrongly
connected. Check the electrical
connections.
The hob simply switches off. You accidentally touched the
On/Off button or touched two
buttons at the same time. Switch the hob back on.
Fault code ER22. The control panel is fi lthy or
has water on it. Clean control panel.
Fault code E2. The hob has overheated. Let the hob cool down and then
use a lower setting.
Fault code U400 The voltage is too high
and/or the hob is not properly
connected. Have your connection changed.
Fault code .
You held a button too long. Do not hold the button too long.
Other fault codes. Defective generator. Contact the service
department.
Safety instructions for the installation
• The connection must comply with national and local
regulations.
• The appliance must always be earthed.
• This appliance may only be connected by a competent
electrical installer.
• For the connection, use an approved cable in accordance with
the regulations. The cable casing should be of rubber.
• The connection cable must hang freely and is not to be fed
through a drawer.
• If you want to make a fi xed connection, make sure that a multi-
polar switch with a contact separation of at least 3 mm is fi tted
in the supply line.
• The worktop the hob is built into must be fl at.
• The walls and the worktop surrounding the appliance must be
heat resistant up to at least 85 °C. Even though the appliance
itself does not get hot, the heat of the hot pan could discolour
or deform the wall.
• Damage caused by incorrect connection, installation or use,
will not be covered by the guarantee.
26
Installation instructions
What you need to
consider