Gooxi ST401-S36REH-G2, User'S Operation Manual

Page: 24 / 62

Shenzhen Gooxi Technology Co., Ltd.
2.3 Connection cable
The cable section is mainly concentrated in the controller module and is used
to connect two 2.5-inch hard disks. There are three different cables: two SATA
high-speed cables and one HDD POWER cable. All other structures of the system
are connected by high-speed signal terminals and have no cable design.
2.4 Jumper settings
There are 3 2PIN pins in the G2SCW-4B motherboard. The following chart
shows the differences and functions of these 2PIN pins:
The above 3 pin positions are as follows:
G2SCW-4B single board 2PIN pin use
2PIN pin
number
description default setting
J18 ME UPDATE No need to insert
jumper cap
J17 ME Recovery No need to insert
jumper cap
J16 CMOS Clear No need to insert
jumper cap
1. J18 Introduction: Use 2PIN jumper cap to insert J18, then short J18. At this
time, close the security mechanism of SPI FALSH ME, users can upgrade ME
Firmware, and when upgrading ME, use to short-circuit.
2. J17 introduction: When inserting J17 using 2PIN jumper cap, shorting J17
will restrict the system's access to ME functions. However, the Firmware update and
upgrade of ME is not limited. Under normal circumstances, it cannot be shorted.
3. J16 introduction: Use 2PIN adjustment cap to insert J16, then use Clear
CMOS.
2.5 Power Module