Then press “CENTER” to select the Cr menu. Some codes
will begin flashing on the display. Ignore these codes and
hold down the “LEFT” and “RIGHT” buttons simultaneous-
ly for at least 10 seconds. If the display switches to “Cr”
again, check that the Bluetooth Shared Data Loader is
inserted fully into the connector and is powered on.
After holding “LEFT” and “RIGHT” for 10 seconds, the
display will start flashing a new code, once this new code
appears, release the “LEFT” and “RIGHT” buttons. The
equipment will display the options “YES” and “no” to con-
firm or cancel the Shared Data loading process. To confirm,
press the “RIGHT” button to select “YES”.
Then press the “CENTER” button
twice
to confirm the
selection. The board will then start the Shared Data loading
process. Once the Shared Data Loading process is com-
plete, the display will return to displaying “Cr”.
To load Shared Data onto a
ComfortBridge
unit, first insert
the card into the Shared Data programming connector on
the control board inside the desired
ComfortBridge
unit.
Then ensure the board is receiving power. Once the board
is fully powered on, use the “LEFT”, “RIGHT”, and “CEN-
TER” buttons on the control board to navigate the appropri-
ate menus on the control board.
Press the “RIGHT” button until the display reads “Cr”.
Loading Shared Data onto ComfortBridge™ Equipment
