Fig. 2
Preparation
Fixture Installation
english
DO NOT USE THIS FIXTURE WITH A DIMMING CIRCUIT.
If you presently have dimmer controls,
you will need to remove them and replace them with regular electrical switches. If you have a
three way dimmer, you will have to replace it with a regular three way switch.
If you are unfamiliar with electrical installations, we recommend you have a qualified
electrician do your installation.
Important Safety Instructions
This light has a polarized plug (one blade is wider than the other) as a safety feature to reduce
the risk of electric shock. This plug will only fit in a polarized outlet one way. If the plug does not
fit, contact a qualified electrician. Never use with an extension cord unless the plug can be fully
inserted.
DO NOT ALTER THE PLUG.
INSTRUCTIONS PERTAINING TO A RISK OF FIRE, ELECTRIC SHOCK, OR INJURY TO PERSONS.
IMPORTANT SAFETY INSTRUCTIONS.
WARNING:
To reduce the risk of
FIRE, ELECTRIC SHOCK, OR INJURY TO PERSONS:
1. Turn off/unplug and allow to cool before replacing bulb (lamp).
2. Use only with a linear fluorescent bulb:
Bulb #F15T8 15W (G9318-T8-WHI);
Bulb #F18T8 18W (G9124P-T8-WHI); Bulb #F25T8 25W (G9336P-T8-WHI).
3. Handle bulb(s) with care during replacing. The glass tube of bulb is very fragile and can
break easily.
IMPORTANT:
Fluorescent bulbs are included with your Good Earth Lighting® fixture. In order to
protect the bulb during shipment, your bulb(s) may be packed in a separate area of the packing
materials. Additionally, your bulbs may already be placed into their respective sockets, but may
have a protective support collar slipped over the bulb. Do
NOT
operate you fixture with this
support collar in place. You can either cut this collar off or remove the bulb from the sockets
and slide the support collar off the bulb. Discard the support collar. You may want to put the
bulb(s) in a safe place until your assembly is complete.
Before installation, plug fixture in to a 120V 60Hz electrical outlet to check for proper operation.
Then unplug and begin the installation.
SAVE THESE INSTRUCTIONS
DO NOT ATTEMPT TO INSTALL THIS LAMP WHILE IT IS PLUGGED IN. THIS LAMP IS FOR
INDOOR USE ONLY.
Fig. 1
1
5
2
3
4
Remove the bulb from the fixture by placing your thumbs on the
metal ends of the bulb. While applying slight pressure on the
bulb, roll the bulb toward you until the contact pins on the ends
of the bulb disengage from the socket. Pull the bulb straight out
from the socket and set aside during mounting (
Fig. 2
).
Using a small drill or nail, make two small starter holes at the
marked locations (
Fig. 4
).
Screw in the two #8 mounting screws until there is
approximately 1/8" of space remaining under the head of the
screw (
Fig. 5
).
Remove the diffuser by pulling back and up on the top edge of
the diffuser using your fingertips (
Fig.
1).
Fig. 3
Fig. 3
Fig. 4
Fig. 5
Place fixture up to mounting surface and mark position of the
narrow end of the keyslot holes on the mounting surface with
a pencil (
Fig. 3
). The screw hole locations must be exact for
the fixture to mount properly.
Slide the fixture over until the narrow legs of the keyhole slots
are under the heads of the screws (
Fig. 6
). Finish tightening
the screws until they are firmly seated, and the fixture is
tightly secured to the mounting surface.
6
Fig. 6
- 2 -
