golmar Vista Nexa, Instruction Manual

Page: 17 / 48

108
LOCK RELEASE INSTALLATION
I
nstalling the FA-PLUS/C power supply.
M 4 x 8
DIN-7972
DIN-963
POWER SUPPLY INSTALLATION
L
ock release installation.
Replace the protection cover once the input terminals have been wired.
It's recommended to protect the power supply by using a
thermo-magnetic circuit breaker.
To install the power supply directly on the wall, drill two holes of
Ø6mm. and insert the wallplugs. Fix the transformer with the
specified screws.
The power supply can be installed on a DIN 46277
guide simply pressing it.
To disassemble the power supply from the DIN guide,
use a plain screwdriver to lever the flange as shown
on the picture.
The FA-Plus/C model uses 6 units over DIN guide.
If the lock release will be installed in a metal door, use a Ø3,5mm.
drill and tap the hole Ø3mm. drill . In case of wood door, use a .
Install the power supply in a dry and protected place without risk of drip or water projections.
To avoid an electrical shock, neither remove the primary protection cover nor handle the connected
wire in the terminals.
The installation and handling of these equipments must be performed by and
authorised personnel
without the power connected
.
To avoid damage, the power supply has to be firmly fixed.
DIN 46277
107
DOOR PANEL INSTALLATION
C
lose the door panel.
D
oor panel assembly.
In assemblies of a single door panel, it is ready from factory
to be mounted.
IMPORTANT:
To make these adjustments of joining several door panels, see the
document that is supplied with the door panel and follow the
steps that are described in the section" Mechanical assembly
for double door panel" and once finished the adjustments stick
the adhesive gasket (that is supplied with the push buttons
module) in the rod of joining modules.
If the door panel to installing is of more than one module it will be
necessary make some adjustments to join a door panel with
other one.
Fix the door panel by using the supplied screws.
Finish the door panel assembly by placing the closing
heads, put the head on one side and then make a slight
pressure on the other end, to its correct placement.
IMPORTANT:
- The lock release must be of (Golmar) 12Vd.c or a.c.
(See page 125 (a.c lock release) and pages 123, 127-130 (d.c lock release).
- A varistor is supplied with the sound module. In case to connect an a.c. lock release,
place the varistor on the lock release terminals directly to ensure a proper system operation.